1000 x 800mm offset quadrant shower trays offer a strong balance of comfort and space saving for modern en-suites and family bathrooms. The 1000mm width gives a more generous showering area, while the 800mm length still works well in corner layouts where a full rectangular tray may feel too sharp or bulky. The curved front keeps the enclosure looking softer and helps maintain easier movement through the room. This is a popular middle size when compact trays feel too restricted but larger walk-in layouts are not practical.

Filter

TAILS’ CORNER FOOTPRINT

Gain useful length without a sharp corner

A 1000 x 800mm offset quadrant shower tray provides extra length along one wall while keeping the return relatively compact. Its curved outer edge reduces the intrusion of a square corner, making this asymmetric footprint useful where comfortable showering space and easier movement around nearby fittings must be balanced.

Is a 1000 x 800mm Offset Quadrant Shower Tray Right for Your Corner?

Compare wall lengths, curved-front clearance and enclosure orientation

A 1000 x 800mm Offset Quadrant Tray Suits You If

One wall offers more length

The 1000mm side uses a longer wall run to create additional standing space, while the 800mm return limits how far the enclosure extends along the adjoining wall. This can suit compact bathrooms with an uneven corner allocation.

A square corner would obstruct movement

The curved frontage removes the projecting outer corner found on a rectangular tray of comparable wall dimensions. This may improve the route past a basin, toilet or doorway where circulation runs close to the enclosure.

You can match the complete enclosure

Purchasing a compatible 1000 x 800mm offset quadrant enclosure helps ensure the curve, handing and adjustment range correspond with the tray. Nominally equal products from unrelated ranges should not be assumed to share the same front radius.

Another Tray Footprint May Suit You Better If

Both available walls are similar

A standard quadrant footprint may create a more balanced corner installation where neither wall offers a useful longer run. The offset shape provides its main advantage when the room can accommodate 1000mm on one side but only 800mm on the other.

The longer side faces the wrong way

An unsuitable orientation can place the 1000mm return against a doorway, boxed service or shorter wall. Check the individual plan drawing because left- and right-hand descriptions may refer to different viewing positions between manufacturers.

You need a straight-fronted entrance

A rectangular tray may work better where the enclosure must align with a straight partition, furniture edge or wider linear doorway. The curved front requires a specifically shaped enclosure and creates a different entrance position within the corner.

1000 x 800mm Offset Quadrant Shower Tray FAQs

Wall measurement, curve matching and orientation clarified

  • Which sides measure 1000mm and 800mm?

    These dimensions normally refer to the two straight edges that meet the bathroom walls. Use the product plan to identify which wall receives the longer side, as the curved frontage makes measuring across the exposed face less useful.

  • Will any matching-size curved enclosure fit?

    No. The enclosure must match the tray’s precise curve, straight-edge dimensions, adjustment range and orientation. Two products labelled 1000 x 800mm can still use different radii, so confirm stated compatibility before combining separate ranges.

  • How do I establish the correct orientation?

    Mark the 1000mm and 800mm wall runs on the finished floor, then compare the curved front and entrance position with the manufacturer’s overhead drawing. Base the decision on the drawing rather than the left- or right-hand label alone.

DESIGNER’S NOTE

Run the 1000mm side along the stronger wall and leave the curved corner facing the main circulation route, making the asymmetric footprint feel purposeful and easy to navigate.